Description
Product Summary
The Honeywell Residential Y8610U6006 is an igniter / flame sensor from Honeywell Residential, described by the manufacturer as: retrofit kit for natural or LP gas 270000 BTU converts from standing pilot to intermittent pilot systems. It replaces Y8610U3003.
Igniters, flame sensors, pilots and thermocouples handle the lighting and flame-proving side of a gas or oil burner. The igniter or pilot lights the gas, and the flame sensor, thermocouple or thermopile tells the control that flame is present. A cracked or weak igniter, a sooty pilot, or a flame sensor with a low microamp reading are common reasons a burner lights and then shuts off or never lights at all.
Before you order, match Y8610U6006 to the part number on the part you are replacing or in your equipment's repair parts list, and confirm the voltage, size and connections match your equipment. If you are not sure which part your equipment needs, call us at 1.888.509.3391 with the model and serial number and we will confirm it for you.
Key Features
- Genuine Honeywell Residential part: Manufacturer part number Y8610U6006, factory new.
- Cross-reference: Replaces Y8610U3003.
- Part type: Igniter / Flame Sensor.
- Ready to ship: In stock with live quantities shown on this page.
Frequently Asked Questions
Is this a genuine Honeywell Residential part?
Yes. This is the Honeywell Residential Y8610U6006, a factory-new igniter / flame sensor from Honeywell Residential.
How do I make sure it fits my equipment?
Compare Y8610U6006 with the part number printed on the part you are replacing or listed in your equipment's repair parts list, and confirm the voltage and connections match. If you are not sure, call us at 1.888.509.3391 with your model and serial number and we will confirm it.
What part numbers does the Y8610U6006 replace?
The Honeywell Residential Y8610U6006 replaces Y8610U3003.
Can I clean a flame sensor instead of replacing it?
Often, yes. Cleaning the rod restores the signal in many cases. Replace it if the porcelain is cracked or the signal stays low after cleaning and checking the ground.
Should a professional install this part?
Yes. Gas, electrical, hydronic and combustion components should be installed by a qualified technician who can test the system afterward and follow the codes that apply where you live.
