Buying guidance

Pool & Filter Systems

Compare
Show: 12 24 48
Show: 12 24 48

An inground pool pump and filter system gives you the two pieces every pool runs on, matched by the same manufacturer and sized for your pool. We build each system for the most common inground pool sizes, using the same method pool builders use: start with the water volume, work out the flow the pool needs, then pick a pump and filter that handle that flow with room to spare.

Shop by pool size

How every system is sized

Each system assumes a 6 ft average depth, so it holds up for deep ends and diving wells. The pump is sized to turn the full volume over in about 6 hours plus 20 GPM for up to four deck jets or bubblers. The cartridge filter is sized at a conservative 0.375 GPM per square foot, which keeps pressure low and cleanings infrequent. Nothing on these pages is sized slightly under.

Pentair, Jandy and Hayward systems

Every system pairs a pump and filter from one brand. Pentair systems use SuperFlo VST, WhisperFlo VST or IntelliFlo3 pumps with Clean and Clear filters. Jandy systems use FloPro or Stealth pumps with CS and CV filters. Hayward systems use Super Pump VS or TriStar VS pumps with SwimClear filters.

Standard, Better and Best

Tiers follow each manufacturer's pump lineup, from value pumps to quieter, premium lines. Every tier is sized to the same standard, so the difference is in features, noise and build quality, never in whether the system can keep up with your pool.

Understanding WEF

WEF, or Weighted Energy Factor, is the Department of Energy efficiency rating on every pool pump label, shown in each system title. Higher numbers mean more water moved per kilowatt-hour. Bigger pumps carry lower numbers because they are rated at higher flows, so compare WEF between pumps of a similar size.

Chlorine or salt water

Chlorine systems include the pump and filter. Salt water systems add a salt chlorine generator matched to the same brand and sized above your pool's volume. Use the Sanitization filter to see either one.

Pool and spa systems and smart systems

Pool and spa systems add a second variable speed pump dedicated to the spa jets and a 400,000 BTU natural gas heater that is certified Low NOx, sized for a typical attached spa of about 7 by 7 feet with six to eight jets and a spillover. Smart systems add the manufacturer's own automation, such as Pentair IntelliConnect, Jandy AquaLink or Hayward OmniPL, so the pump, salt system and connected equipment can be scheduled and controlled from your phone. Use the System Type and Smart Control filters on this page to narrow the list.

Frequently asked questions

What is included in a pool pump and filter system?

One variable speed pool pump and one cartridge filter from the same manufacturer, plus a salt chlorine generator on salt water systems. Pipe, valves, fittings, wiring and installation are supplied by your installer.

How do I know which size to choose?

Pick the size that matches your pool's length and width. If your pool falls between two sizes, choose the larger one. If you have an attached spa or large water features, choose a pool and spa system or add a water feature pump.

Why variable speed?

A variable speed pump runs at low speed for most of the day, which uses far less electricity and runs much quieter, then ramps up when you need more flow for cleaning or water features.

Are cartridge filters better than sand?

Cartridge filters catch finer particles than sand, need no backwashing, and save water. They are cleaned by rinsing the cartridge a few times a season.