Description
Product Summary
This Pentair equipment package pairs the SuperFlo VST 2.2 HP variable speed pool pump (342002) with the Pentair Clean and Clear 200 sq ft cartridge filter (160353). It is sized for a 14' x 28' in-ground pool (about 17,640 gallons), based on a 6 ft average depth, so it holds up for deeper pools and diving ends too. Both pieces come from the same brand, so the pump and filter are a natural match for a new equipment pad or a full replacement.
This system adds a Pentair UltraTemp heat pump pool heater rated at 110,000 BTU with a COP of 6.1. A heat pump moves heat from the outside air into the water instead of burning fuel, so it costs far less to run than gas and has no emissions restrictions anywhere. We size heat pumps with the standard formula of pool surface area times temperature rise times 12. A 14' x 28' pool has 392 square feet of surface, so a 20 degree rise calls for about 94,080 BTU, and this heat pump covers it. Heat pumps work best when the air is above about 50 degrees, which makes them the most popular choice in warm climates.
Sizing follows the common residential rule of turning the full pool volume over in about 8 hours. For 17,640 gallons that works out to roughly 37 gallons per minute, well within this pump's range at low, energy-saving speeds and within the 150 GPM rating of the filter. A cartridge filter needs no backwashing and no multiport valve: you rinse the cartridge with a hose a few times a season, which saves water and makes this the simplest filtration setup for most homeowners.
Variable speed pumps are the standard for new in-ground pools because they run most of the day at low speed and use a fraction of the energy of a single speed pump. Electrical work and final plumbing should be done by a licensed pool or electrical professional, following local codes.
Key Features
- Matched Pentair pad: pump and filter from one brand, sized together for 14' x 28' pools.
- Variable speed savings: the 2.2 HP SuperFlo VST runs at low speeds most of the day to cut energy use. Onboard keypad.
- 200 sq ft cartridge filtration: no backwashing and no multiport valve, just rinse the cartridge when the pressure rises.
- Ready for upgrades: add a heater, salt system or lights to this pad later as your pool grows.
Frequently Asked Questions
What size pool is this package for?
It is sized for a 14' x 28' in-ground pool (about 17,640 gallons). Sizing already assumes a 6 ft average depth. If your pool has an attached spa or water features, choose the next size up.
What is included?
One Pentair SuperFlo VST 2.2 HP variable speed pump (342002) and one Pentair Clean and Clear 200 sq ft cartridge filter (160353). Plumbing pipe, fittings, valves and wiring are not included. It also includes a UltraTemp 110K BTU heat pump pool heater (460932).
Does a cartridge filter need a backwash valve?
No. Cartridge filters are cleaned by removing and hosing off the cartridge, so no multiport or backwash valve is needed.
Can I add a heater or salt system later?
Yes. This pad leaves room for a heater, salt chlorine generator and lights, which can be added now or later.
