Description
Product Summary
This Pentair equipment package pairs the IntelliFlo3 VSF 3 HP variable speed pool pump (011076) with the Pentair Clean and Clear Plus 320 sq ft cartridge filter (160340). It is sized for a 18' x 36' in-ground pool (about 29,160 gallons), based on a 6 ft average depth, so it holds up for deeper pools and diving ends too. Both pieces come from the same brand, so the pump and filter are a natural match for a new equipment pad or a full replacement.
Sizing follows the common residential rule of turning the full pool volume over in about 8 hours. For 29,160 gallons that works out to roughly 61 gallons per minute, well within this pump's range at low, energy-saving speeds and within the 120 GPM rating of the filter. A cartridge filter needs no backwashing and no multiport valve: you rinse the cartridge with a hose a few times a season, which saves water and makes this the simplest filtration setup for most homeowners.
Variable speed pumps are the standard for new in-ground pools because they run most of the day at low speed and use a fraction of the energy of a single speed pump. Electrical work and final plumbing should be done by a licensed pool or electrical professional, following local codes.
Key Features
- Matched Pentair pad: pump and filter from one brand, sized together for 18' x 36' pools.
- Variable speed savings: the 3 HP IntelliFlo3 VSF runs at low speeds most of the day to cut energy use. Onboard keypad with I/O board.
- 320 sq ft cartridge filtration: no backwashing and no multiport valve, just rinse the cartridge when the pressure rises.
- Ready for upgrades: add a heater, salt system or lights to this pad later as your pool grows.
Frequently Asked Questions
What size pool is this package for?
It is sized for a 18' x 36' in-ground pool (about 29,160 gallons). Sizing already assumes a 6 ft average depth. If your pool has an attached spa or water features, choose the next size up.
What is included?
One Pentair IntelliFlo3 VSF 3 HP variable speed pump (011076) and one Pentair Clean and Clear Plus 320 sq ft cartridge filter (160340). Plumbing pipe, fittings, valves and wiring are not included.
Does a cartridge filter need a backwash valve?
No. Cartridge filters are cleaned by removing and hosing off the cartridge, so no multiport or backwash valve is needed.
Can I add a heater or salt system later?
Yes. This pad leaves room for a heater, salt chlorine generator and lights, which can be added now or later.
