Description
TradePro TP-2W2 Hard Start Kit, 3.5 to 5 HP
The TradePro TP-2W2 hard start kit pairs a mechanical potential relay (MPR) with a start capacitor to give a single-phase compressor extra starting torque. It is sized for compressors of 3.5 to 5 HP (roughly 3.5 to 5 ton air conditioners and heat pumps). A hard start kit helps compressors that struggle to start against unequalized pressures, on long line sets, during low voltage or after short cycling, and it shortens the high-current start period that strains the compressor and contactor.
Why a potential relay kit
- The mechanical potential relay drops the start capacitor out of the circuit once the compressor reaches speed, based on back EMF rather than a timer
- Wires in parallel with the existing run capacitor, so the run circuit stays as designed
- Matches the start boost to the compressor size range instead of a one-size-fits-all PTC device
Before you install
Confirm the compressor horsepower or RLA falls in the 3.5 to 5 HP range, check that the run capacitor is in spec first (a failed run capacitor causes many hard-start complaints), and follow the wiring diagram included with the kit with power off at the disconnect.
