Description
Enjoy warm water all season at a fraction of the cost of gas with the Raypak WeatherKing 6560 TWPH-6560EHT01. It delivers about 118,000 BTU per hour of heating capacity. It can also cool the water on hot days.
WeatherKing is Raypak's (Rheem family) value heat pump line: scroll compressor, spiral titanium heat exchanger and digital controls, heat only. In this guide we explain how it works, how to size it, what electrical service it needs and how to get the best performance in your climate.
Quick Answer: What Is the Raypak WeatherKing 6560 TWPH-6560EHT01?
The Raypak WeatherKing 6560 TWPH-6560EHT01 is an electric heat pump pool heater rated at about 118,000 BTU/hr. It uses a refrigerant cycle to move heat from the outdoor air into the pool water, delivering several units of heat for every unit of electricity it uses.
Raypak WeatherKing 6560 TWPH-6560EHT01 Specifications
| Brand | Raypak |
|---|---|
| Equipment Type | Heat Pump Pool Heater |
| Model Number | TWPH-6560EHT01 |
| Product Line | WeatherKing 6560 |
| Heating Capacity (BTU) | 118,000 |
| Heat Exchanger | Titanium |
| Voltage / Phase | 208-230V 1-Phase |
| Warranty | 7 years parts, 2 years labor, 10 years heat exchanger |
Key Features of the Raypak WeatherKing 6560 TWPH-6560EHT01
- 118,000 BTU heating
- Spiral titanium heat exchanger
- Quiet high-efficiency scroll compressor
- Digital controls
- Heat only - no cooling mode
How a Heat Pump Pool Heater Works
A heat pump works like an air conditioner in reverse. A fan draws outdoor air across an evaporator coil, where refrigerant absorbs heat from the air. A compressor raises the refrigerant's temperature, and a heat exchanger, usually titanium for corrosion resistance, transfers that heat to the pool water. The refrigerant then cycles back to collect more heat.
Efficiency is measured by the coefficient of performance (COP). A COP of 5 means the heater delivers five units of heat for every unit of electricity, so each kilowatt-hour can deliver roughly 5 x 3,412 BTU to the water. Heat pump ratings are commonly published at 80 F air, 80 percent humidity and 80 F water; output drops as the air gets cooler, and most units are designed to operate down to around 45 to 50 F.
How to Size a Pool or Spa Heater
Raising one gallon of water one degree Fahrenheit takes about 8.33 BTU. Multiply your gallons by 8.33 and by the temperature rise you want to find the total heat needed, then divide by the heater's output to estimate hours. Heat pumps heat more gradually than gas, so they are best at maintaining temperature. Size for your pool's surface area, your coolest swimming month and how warm you like the water. In cooler regions, choose a larger model or pair it with a cover.
At its rated 118,000 BTU/hr, running 24 hours, the approximate temperature rise before heat losses is:
| Pool size | Approximate rise |
|---|---|
| 10,000 gal | 34.0 F per day |
| 15,000 gal | 22.7 F per day |
| 20,000 gal | 17.0 F per day |
| 25,000 gal | 13.6 F per day |
| 30,000 gal | 11.3 F per day |
Real-world results depend on air temperature, humidity, wind and whether you use a cover. A cover can make a dramatic difference by reducing evaporation, the largest source of heat loss.
Good, Better, Best: Where the Raypak WeatherKing 6560 TWPH-6560EHT01 Fits
At HVAC365 we organize every category into a simple Good, Better, Best framework so you can compare options without wading through jargon. Within our heat pump pool heater lineup, this model sits in the Good tier: Essential features at a great value.
The Good tier is built around affordability and simplicity. You get dependable, proven equipment without paying for extras you may never use. It is the smart pick for first-time buyers, straightforward replacements, and bulk B2B or government purchases where consistent, budget-friendly specs matter most.
Not sure the Good tier is right for you? Compare it with the Better and Best options in the same category. Whatever tier you choose, the equipment is brand new and covered by the full manufacturer warranty, and our team is here to help you weigh features against budget.
Installation and Electrical Requirements
This heater requires a dedicated electrical circuit (208-230V 1-Phase). A licensed electrician should size the wire and breaker and provide a service disconnect as required by code. The heater is plumbed after the filter and before any chlorinator, and it needs adequate water flow for the flow switch to engage.
Heat pumps need open airflow: leave the clearances shown in the manual on all sides and above the unit, avoid enclosing it under decks or in tight corners, and place it on a level pad that allows condensation to drain away. Condensation is normal and can look like a leak on humid days.
Professional installation is recommended.
Maintenance Tips
- Keep pool chemistry balanced to protect the heat exchanger and element.
- Keep the coil fins clean and clear of leaves, grass clippings and debris; rinse gently with a garden hose.
- Make sure the condensate can drain freely.
- Have a technician inspect electrical connections annually.
- In freezing climates, drain the heater and plumbing when the pool is closed for winter.
Best Climates for Heat Pump Heating
Heat pumps shine in the South and Sun Belt, including Florida, Texas, Arizona, the Gulf Coast and Southern California, where warm, humid air provides plenty of heat to harvest for most of the year. In the North, they work well for the core summer season, and many owners pair one with a gas heater for spring and fall or for a spa. Models with a cooling mode are popular in the hottest regions, where pool water can become uncomfortably warm in mid-summer.
What's Included and Compatibility
This listing is for the Raypak WeatherKing 6560 TWPH-6560EHT01. Unions and automation accessories may be sold separately.
Manufacturer warranty: 7 years parts, 2 years labor, 10 years heat exchanger.
Ideal for:
- In-ground and above-ground pools up to roughly 25,000 gal
- Budget heat pump replacement
- Warm-climate pool heating
Heat Pump vs Gas vs Electric Resistance Heat
| Heater type | Heat-up speed | Operating cost | Best for |
|---|---|---|---|
| Heat pump | Gradual | Low in warm weather | Season-long pool heating in mild and warm climates |
| Gas (natural or propane) | Fast | Higher, varies with fuel price | Spas, occasional heating, cold climates |
| Electric resistance | Steady, size-limited | Higher per BTU | Spas and small bodies of water |
Many owners combine heat sources: a heat pump to hold the pool temperature through the season and a gas heater for quick spa heat or cold snaps. Covers reduce heat loss no matter which heater you choose.
Built for Homeowners, Contractors and Property Managers
- Homeowners: use our sizing tools and the pool math on this page, then reach out with your pool size, location and existing equipment. We will help you confirm the right model before you order.
- Contractors and installers: order in two clicks, follow every shipment with live tracking, and reorder common parts from the HVAC365 Contractor Portal. We know the labor shortage is real, so we focus on getting the right part to the job the first time.
- Property managers: manage equipment for multiple properties from one dashboard and book a strategy call with our team to standardize models, plan replacements and control maintenance costs.
Frequently Asked Questions About the Raypak WeatherKing 6560 TWPH-6560EHT01
How much will the Raypak WeatherKing 6560 TWPH-6560EHT01 raise my pool temperature?
At about 118,000 BTU/hr running all day, roughly 17.0 F per day for a 20,000-gallon pool before losses. A cover helps significantly.
Do heat pumps work in cold weather?
They work best above about 50 F. As the air cools, capacity and efficiency drop, and most units stop heating near their low-temperature limit.
Are heat pumps cheaper to run than gas?
In warm climates, usually yes, because they move heat rather than burning fuel. Your savings depend on local electricity and gas prices.
What electrical service does it need?
208-230V 1-Phase. Have a licensed electrician install a dedicated circuit and disconnect.
Is water dripping from the unit normal?
Yes. Heat pumps produce condensation as they pull heat from humid air. It can be several gallons per hour on humid days.
What warranty does it have?
7 years parts, 2 years labor, 10 years heat exchanger.
