Description
Product Summary
This Jandy equipment package pairs the FloPro VS 1.65 HP variable speed pool pump (VSFHP165DVS) with the Jandy CS Series 200 sq ft cartridge filter (CS200). It is sized for a 14' x 28' in-ground pool (about 17,640 gallons), based on a 6 ft average depth, so it holds up for deeper pools and diving ends too. Both pieces come from the same brand, so the pump and filter are a natural match for a new equipment pad or a full replacement.
Because this system also runs an attached spa, it adds a second Jandy FloPro VS variable speed pump dedicated to the spa jets, sized for a typical attached spa of about 7 by 7 feet with six to eight jets and a spillover into the pool. Heat comes from a Jandy JXi 400,000 BTU natural gas heater that is certified Low NOx, so it meets the clean air rules used in the strictest regions and brings a spa up to temperature quickly. A Jandy TruClear salt chlorine generator rated for up to 35,000 gallons covers the pool and spa together. Your installer supplies the pool and spa valves, plumbing and gas line.
Sizing follows the common residential rule of turning the full pool volume over in about 8 hours. For 17,640 gallons that works out to roughly 37 gallons per minute, well within this pump's range at low, energy-saving speeds and within the 125 GPM rating of the filter. A cartridge filter needs no backwashing and no multiport valve: you rinse the cartridge with a hose a few times a season, which saves water and makes this the simplest filtration setup for most homeowners.
Variable speed pumps are the standard for new in-ground pools because they run most of the day at low speed and use a fraction of the energy of a single speed pump. Electrical work and final plumbing should be done by a licensed pool or electrical professional, following local codes.
Key Features
- Matched Jandy pad: pump and filter from one brand, sized together for 14' x 28' pools.
- Variable speed savings: the 1.65 HP FloPro VS runs at low speeds most of the day to cut energy use. SpeedSet controller included.
- 200 sq ft cartridge filtration: no backwashing and no multiport valve, just rinse the cartridge when the pressure rises.
- Ready for upgrades: add a heater, salt system or lights to this pad later as your pool grows.
Frequently Asked Questions
What size pool is this package for?
It is sized for a 14' x 28' in-ground pool (about 17,640 gallons). Sizing already assumes a 6 ft average depth. If your pool has an attached spa or water features, choose the next size up.
What is included?
One Jandy FloPro VS 1.65 HP variable speed pump (VSFHP165DVS) and one Jandy CS Series 200 sq ft cartridge filter (CS200). Plumbing pipe, fittings, valves and wiring are not included. It also includes a FloPro VS 1.85 HP spa pump (VSFHP185DV2AS), a JXi 400,000 BTU Low NOx natural gas heater (JXI400N) and a TruClear salt chlorine generator (TRUCLEAR11KU).
Does a cartridge filter need a backwash valve?
No. Cartridge filters are cleaned by removing and hosing off the cartridge, so no multiport or backwash valve is needed.
Can I add a heater or salt system later?
Yes. This pad leaves room for a heater, salt chlorine generator and lights, which can be added now or later.
