Description
Smart Electric SBD-083S Bi-Directional Heat Pump Filter Drier
The Smart Electric SBD-083S is an 8 cubic inch bi-directional filter drier built for heat pumps, where refrigerant reverses direction between heating and cooling. Internal check valves let it filter in both directions, so the system stays protected in every mode without needing two driers. It has 3/8" ODF copper sweat connections made to be brazed directly into the line.
Size the drier to the system tonnage and line size, and install it as close to the component it protects as practical. Like any filter drier, it should be brazed or connected with the system evacuated and protected from moisture until it is sealed in.
Key Features
- Filters and dries in both directions, made for heat pump liquid lines
- 8 cubic inch desiccant capacity for moisture and acid removal
- Copper ODF sweat ends for a leak-tight brazed joint
- Compatible with R-22, R-410A, R-134a, R-404A, R-407C, R-507 (CFC, HCFC and HFC)
Frequently Asked Questions
Can I use a standard liquid line drier on a heat pump?
A standard drier only filters in one direction. On a heat pump the flow reverses, so a bi-directional drier like this one is the right choice when the drier sits in the common liquid line.
When should the drier be replaced?
Replace the filter drier any time the refrigerant circuit is opened for a repair, such as a compressor, coil or metering device change.
