Description
Rheem 6 Ton Commercial Heat Pump Package Unit (RHPCYB072A)
The Rheem RHPCYB072A is a Commercial Classic Series packaged heat pump for 208/230V three-phase light commercial buildings. The compressor, both coils and the indoor blower are in one cabinet, so the unit sits on a roof curb or a ground pad and connects to the building's ductwork. The airflow converts between downflow and horizontal side flow in the field.
This model ships with the high-static, direct-drive constant torque ECM blower (factory configuration RHPCYB072ACU000AAAA0), which suits longer duct runs and roof curb installs with higher external static pressure.
Cabinet and Airflow
- Airflow: 2,400 CFM nominal, 1.2 HP direct-drive ECM blower
- Configuration: convertible, vertical downflow or horizontal side flow
- Coils: MicroChannel evaporator and condenser, TXV metering
- Service features: PlusOne ServiceSmart package with Qwik-Slide blower, Qwik-Change filter rack and Qwik-Clean drain pan; overflow condensate sensor; dual 7-segment LED diagnostics; external lockable gauge ports
- Controls: standard Modbus interface
- Base: forkable base rails for lifting and rigging
Sizing and Installation
Size the unit with a Manual J load calculation (or a commercial load calculation for the building). Installation requires a licensed HVAC contractor: a roof curb or level pad, three-phase power with a disconnect, duct connections and a refrigerant system check at startup. Electric heat, economizers and curb adapters are field-installed accessories ordered separately.
Common Questions
Will this run on single-phase power?
No. The RHPCYB072A requires 208/230V three-phase power.
Is it downflow or horizontal?
Either. The supply and return openings convert in the field.
Does it include a thermostat?
No. A compatible two-stage heat pump thermostat is purchased separately.
White Paper
